Filter Unit in Drilling Waste Management

Now with the strictly requirement of environment, the drilling site must do well of waste management.

We new Filter Unit is using Filter Press company with mud tanks. Below is the photo show.

Before using it please check all equipment are in good condition, at the same time fill mixed drilling fluids into chemical feeding tank properly. Check all valves are on right position and then run the filter press to drive the press device.

Press plate should compress filter plates tightly and steadily. Turn on the plunger pump to transfer materials into the filter press. Materials will flow into the filtration room via path on filter plate. Under plunger pump pressure the clean fluids will penetrate out of filter cloth on filter plate then pass through access on filter plate.

After passing filter plate access the fluid will come out together through output port. The clean water after pressed will flow into water collection cabin. There is a set of vertical centrifugal pump on the water cabin to transfer the water into collection tank

The mud cake will be left in the filtration room till the cakes filled full of filtration room, then stop the plunger pump. Turn on the secondary pressing pump and maintain the pressure for a while before release press plate. Then pull the filter plates on by one to the direction of press plate to release mud cakes. The released cakes will be transferred out of the device skid by the belt conveyor. Then the whole device will begin a new circulation.

If you need this Filter Unit, welcome to contact with me: alisa@jxsolidscontrol.com