Centrifugal pump's application
The SB series centrifugal pumps adopt axial suction structure. The flow parts are anti-wear cast iron. In solids control system, the centrifugal pump transfer the drilling fluid, and feeding for Desander, Desilter and Mixing hopper. The main factors are spare parts can easy find and replace, long working life and low cost.
Common using type parameters.
1). Inlet pipe diameter: 200mm
2). Discharge dameter: 150mm
3). Impeller diameter: 315mm
4). Flow rate: 67 l/s
5). Head: 35 m
6). Speed: 1480 rpm
7). Motor power: Ex-prool type, 45 or 55KW
8). Working life: ≥ 2500 hours
The structure of centrifugal pump
Like the upper photo shows, the centrifugal pump's main parts are pump case, pump data base, impeller, shaft, mechanical seal, coupling, motors and data base etc. The centrifugal pump's seal is mechanical seal, thus make sure there is no leak of pumps. The impeller type is half open type, this lower the flow of pump itself.
For more pump 's knowledge, please contact with alisa@jxsolidscontrol.com
Website: http://www.jxsolidscontrol.com
Name: Hebei JinXin Machinery Co., Ltd
没有评论:
发表评论